Canon iPF6400S User Manual page 591

iPF6400S
Adjust Feed Adj.
Printer Priority Quality
Adjust
Length
Adj Far Ed Feed
Calibra- AutoAdjst(HiPrc) ( *2 )
tion
Auto Adjust
ColorCheck Print ( *2 )
Pattern Size ( *2 )
User's Guide
Setting Item
Auto(GenuinePpr)
Auto(OtherPaper)
Manual
Adjust- A:High
ment-
B:Standard/Draft
Print
Change A:High
Settings
B:Standard/Draft
Description, Instructions
The printer prints and reads a test pattern for automatic ad-
justment of the feed amount. (See "Automatic Banding Ad-
justment.")
P.715
➔
Specify this mode with paper not in the Paper Reference
Guide. (See "Displaying the Paper Reference
Guide.")
P.464
➔
The printer prints and reads a test pattern for automatic ad-
justment of the feed amount. Note that this function takes
more time and consumes more ink than Auto(GenuinePpr).
(See "Automatic Banding Adjustment.")
Use this mode with highly transparent media or other paper
for which Auto(GenuinePpr) or Auto(OtherPaper) cannot
be used.
Print a test pattern for adjustment of the feed amount based
on the type of paper. (See "Manual Banding Adjust-
ment.")
P.716
➔
Print a test pattern for particular types of paper to compen-
sate for paper stretching or shrinkage, after which you enter
the amount of adjustment. (See "Adjusting Line
Length.")
P.718
➔
Displayed when you have selected Feed Priority > Adj. Pri-
ority > Print Length.
Adjustment relative to the amount of stretching or shrinkage
of the current paper.
Enter either the adjustment results from AdjustmentPrint or
the discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount by
choosing a higher adjustment value. For paper that tends to
shrink, decrease the feed amount by choosing a lower ad-
justment value. (See "Adjusting Line Length.")
Choose Yes to adjust the feed amount for the trailing edge.
Perform color calibration using the optional Spectrophotome-
ter Unit.
A test pattern for color calibration is printed and the adjust-
ment values are set automatically.
(See "Color Calibration Using the Spectrophotometer Unit (op-
tion).")
P.742
➔
Execute color calibration using the printer sensor.
A test pattern for color calibration is printed and the adjust-
ment values are set automatically.
(See "Color Calibration Using the Printer Sensor.")
Perform a printer color check using the optional Spectropho-
tometer Unit.
Color check is a function that prints and automatically meas-
ures the colors of a test pattern, and calculates the color dif-
ference from a calibration target (standard color values regis-
tered in the printer).
(See "Color Checks Using the Spectrophotometer Unit (op-
tion).")
P.745
➔
The same as ColorCheck Print in the hierarchy under Test
Print.
Select the size of the adjustment pattern printed during color
calibration using the optional Spectrophotometer Unit and
during ColorCheck Print.
Normally, set to Standard.
We recommend that you set it to Large if you want to priori-
tize measurement accuracy.
Menu Settings
P.715
➔
P.718
➔
P.736
➔
591