Canon iPF6400S User Manual page 474

Loading Rolls in the Printer
1
Press the Load button.
2
Press ▲ or ▼ to select Roll Paper, and then press the OK button.
Note
3
Open the Roll Feed Unit Cover.
4
Holding the Roll Holder flange (a), load the Roll Hold-
er shaft into the guide grooves (b) on both sides of
the Roll Holder Slot. At this time, load the shaft so
that the color of the Roll Holder shaft (c) matches the
color of the guide groove.
Caution
Important
Note
474
• If any paper has been advanced that will not be used, a message is shown requesting you to remove it.
Press ▲ or ▼ to select Yes, and then press the OK button. Remove the paper and go to the next step.
• Do not release the flanges until you load the holder fully in the Roll Holder Slot. Rolls are heavy, and dropping a
roll may cause injury.
Be careful not to pinch your fingers between the guide grooves (b) and the Roll Holder shaft (c) when loading
•
rolls.
• Do not force the Roll Holder into the printer with the right and left ends reversed. Otherwise, it may damage the
printer or Roll Holder.
• If it is difficult to load rolls from the front of the printer, load rolls from the back of the printer.
If the printer has a Spectrophotometer Unit (option), lowering the Up-down Unit makes it easier to perform oper-
ations from the front of the printer. (See "Lowering the Up-down Unit of the Spectrophotometer Unit (option) Man-
ually.")
P.494
➔
iPF6400S
User's Guide