Chapter 2. Connecting The Router; System Requirements; Installation Environment Requirements; Connecting The Router - TP-Link TL-WR802N User Manual

Chapter 2. Connecting the Router

2.1 System Requirements

Each PC in the LAN needs a working Ethernet Adapter

TCP/IP protocol must be installed on each PC

Web browser, such as Microsoft Internet Explorer 5.0 or later, Mozilla Firefox, Apple Safari

If the device is configured to Wireless Router/Access Point mode, you also need Broadband

Internet Access Service (DSL/Cable/Ethernet)
One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the Router is

connected directly to the Ethernet.)

2.2 Installation Environment Requirements

Place the Router in a well-ventilated place far from any heater or heating vent

Place the Router in a location where it can be connected to the various devices as well as to

a power source
Avoid direct irradiation of any strong light (such as sunlight)

Keep at least 2 inches (5 cm) of clear space around the Router

Operating Temperature: 0 ℃~ 40℃ (32℉ ~ 104℉ )

Operating Humidity: 10%~90%RH, Non-condensing


2.3 Connecting the Router

Before installing the Router, please make sure your broadband service provided by your ISP is
available. If there is any problem, please contact with your ISP.
Please choose the operation mode you need and carry out the corresponding steps. There are
five operation modes supported by this router: Wireless Router, Hotspot Router, Access Point,
Range Extender and Client.

2.3.1 Wireless Router Mode

As a wireless router, TL-WR802N enables multi-user to share a wired (Ethernet) connection to
wireless devices, such as in a hotel room, small office, etc.
The default mode of TL-WR802N is Wireless Router. On this mode, the wired port LAN/WAN
works as WAN, it can be connected to DSL Modem or directly connected to a wired network with
an Ethernet cable. Devices could connect to the router wirelessly.
TL-WR802N 300Mbps Wireless N Nano Router
- 5 -