Reset To Factory Defaults; Overview; Reset The Switch To Factory Defaults; Network Diagnostics - ZyXEL Communications GS1900 Series User Manual

32.6 Reset to Factory Defaults

32.6.1 Overview

You can reset the Switch to it's original settings.
From the Maintenance screen, display the Factory Default screen as shown next. Use this screen
to reset the Switch back to factory defaults.
Table 181 Maintenance > Configuration > Factory Default

32.6.2 Reset the Switch to Factory Defaults

Follow the steps below to reset the Switch back to factory defaults.
1. Click Restore.
2. Click OK to reset all Switch configurations to the factory defaults. Wait for the Switch to restart.
This takes up to two minutes.
OR
Click Cancel to discard the changes.
Note: If you want to access the Switch web configurator again, you may need to change
the IP address of your computer to be in the same subnet as that of the default
Switch IP address (192.168.1.1).

32.7 Network Diagnostics

Use the network utilities to perform diagnostics.

32.7.1 Port Test

Click Maintenance > Diagnostics > Port Test in the navigation panel to open this screen. Use
this screen to perform an internal loopback test on an ethernet port.
Chapter 32 Maintenance
GS1900 Series User's Guide
219