The Med Port Screen - ZyXEL Communications GS1900 Series User Manual

Table 125 Configuration > LLDP > MED Network Policy > Edit (continued)
LABEL
VLAN ID
VLAN Tag
L2 Priority
DSCP Value
Apply
Cancel

27.2.8 The MED Port Screen

Use this screen to view the MED Port settings. Click Configuration > LLDP > MED Port to open
this screen.
Figure 160 Configuration > LLDP > MED Port
The following table describes the labels in this screen.
Table 126 Configuration > LLDP > MED Port
LABEL
MED Port
Edit
Port
State
Network Policy
Chapter 27 Configuration: LLDP
DESCRIPTION
Enter the VLAN ID (VID) for the port as defined in IEEE 802.1Q-2003. A value of 1 through
4094 is used to define a valid VLAN ID. A value of 0 (Priority Tagged) is used if the device is
using priority tagged frames as defined by IEEE 802.1Q-2003, meaning that only the IEEE
802.1D priority level is significant and the default PVID of the ingress port is used instead.
TAG is indicative of whether the specified application type is using a tagged or an untagged
VLAN. Select Tagged or Untagged.
Untagged: The device is using an untagged frame format and as such does not include a
tag header as defined by IEEE 802.1Q-2003.
Tagged: The device is using the IEEE 802.1Q tagged frame format.
Priority is the Layer 2 priority to be used for the specified application type. One of the
eight priority levels (0 through 7).
DSCP is the DSCP value to be used to provide Diffserv node behavior for the specified
application type as defined in IETF RFC 2474. Contain one of 64 code point values (0
through 63).
Click Apply to save the changes.
Click Cancel to discard the changes.
DESCRIPTION
Select this check box to configure the properties of a port. Click the Edit button change the
properties of the port.
Displays the MED Port value.
Displays the state of the MED port as Enable or Disable.
Displays the Network Policy value.
GS1900 Series User's Guide
169