The Lag Management Screen - ZyXEL Communications GS1900 Series User Manual

Figure 123 Configuration > Link Aggregation > Global
The following table describes the labels in this screen.
Table 89 Configuration > Link Aggregation > Global
LABEL
Global
LACP State
LACP System
Priority
Load Balance
Algorithm
Apply
Cancel

22.2.2 The LAG Management Screen

Use this screen to view LAG management settings. Click Configuration > Link Aggregation >
LAG Management to open this screen.
Figure 124 Configuration > Link Aggregation > LAG Management
Chapter 22 Configuration: Link Aggregation
DESCRIPTION
Select Enable to activate the link aggregation control protocol.
LACP system priority is a number between 1 and 65,535. The switch with the lowest system
priority (and lowest port number if system priority is the same) becomes the LACP "server".
The LACP "server" controls the operation of LACP setup. Enter a number to set the priority
of an active port using Link Aggregation Control Protocol (LACP). The smaller the number,
the higher the priority level.
Select the outgoing traffic distribution type. Packets from the same source and/or to the
same destination are sent over the same link within the trunk. By default, the Switch uses
the IP/MAC Address distribution type. If the Switch is behind a router, the packet's
destination or source MAC address will be changed. In this case, set the Switch to distribute
traffic based on its IP address to make sure port trunking can work properly.
Select MAC Address to distribute traffic based on a combination of the packet's source and
destination MAC addresses.
Select IP/MAC Address to distribute traffic based on a combination of the packet's source
and destination IP addresses.
Click Apply to save the changes.
Click Cancel to discard the changes.
GS1900 Series User's Guide
130