Stp Statistics - ZyXEL Communications GS1900 Series User Manual

Table 45 Monitor > Spanning Tree > MST Port (continued)
LABEL
Indentifier (Priority
/ Port Id)
Internal Path
Cost(Operation)
Regional Root
Bridge
Internal Root Cost
Designated Bridge
Port Role
Port State

14.2.5 STP Statistics

(R)STP detects and breaks network loops and provides backup links between switches, bridges or
routers. It allows a Switch to interact with other (R)STP-compliant switches in your network to
ensure that only one path exists between any two stations on the network.
The Switch uses IEEE 802.1w RSTP (Rapid Spanning Tree Protocol) that allows faster convergence
of the spanning tree than STP (while also being backwards compatible with STP-only aware
bridges). In RSTP, topology change information is directly propagated throughout the network from
the device that generates the topology change. In STP, a longer delay is required as the device that
causes a topology change first notifies the root bridge and then the root bridge notifies the
network. Both RSTP and STP flush unwanted learned addresses from the filtering database. In
RSTP, the port states are Discarding, Learning, and Forwarding.
Note: In this user's guide, "STP" refers to both STP and RSTP.
Use this screen to view the Switch's spanning tree STP statistics. Click Monitor > Spanning Tree
> STP Statistics to access this screen.
Figure 79 Monitor > Spanning Tree > STP Statistics
Chapter 14 Monitor: Spanning Tree
DESCRIPTION
This field displays the identifier (in priority / port number).
Path cost is the cost of transmitting a frame on to a LAN through that port. It is
recommended to assign this value according to the speed of the bridge. The slower the
media, the higher the cost.
Root bridge refers to the base of the spanning tree.
This field displays the internal root cost.
For each LAN segment, a designated bridge is selected. This bridge has the lowest cost
to the root among the bridges connected to the LAN.
This field displays the state of the port role.
This field displays the state of the port.
GS1900 Series User's Guide
83