The Trap Screen - ZyXEL Communications GS1900 Series User Manual

The following table describes the labels in this screen.
Table 166 Configuration > Management > SNMP > User > Add/Modify
LABEL
SNMP User
User Name
Group Name
Auth Protocol
Auth Password
Priv password
Apply
Cancel

31.3.8 The Trap Screen

Use this screen to configure the Trap settings. Click Configuration > Management > SNMP >
Trap to open this screen.
Figure 200 Configuration > Management > SNMP > Trap
Chapter 31 Configuration: Management
DESCRIPTION
Enter a string identifying the user name that this entry belongs to. The allowed string
length is 1 to 30, and the allowed content is ASCII characters from 33 to 126.
Enter a string identifying the group name that this entry belongs to. The allowed string
length is 1 to 30, and the allowed content is ASCII characters from 33 to 126.
Select the authentication protocol that this entry belongs to. Possible authentication
protocols are:
• MD5: An optional flag to indicate that this user uses MD5 authentication protocol.
• SHA: An optional flag to indicate that this user uses SHA authentication protocol.
The value of the security level cannot be modified if the entry already exists. That means
you must first ensure that the value is set correctly.
Enter a string identifying the authentication password phrase. For MD5 authentication
protocol, the allowed string length is 8 to 32. For SHA authentication protocol, the allowed
string length is 8 to 32. The allowed content is ASCII characters from 33 to 126.
Enter a string identifying the privacy password phrase. The allowed string length is 8 to 64
and the allowed content is ASCII characters from 33 to 126.
Click Apply to save the changes.
Click Cancel to discard the changes.
GS1900 Series User's Guide
204