D-Link DAS-3636 Cli Reference Manual page 9

?
cable_diag ports
cfm linktrace
cfm loopback
clear
clear address_binding dhcp_snoop binding_entry ports
clear arptable
clear attack_log
clear cfm pkt_cnt
clear counters
clear ethernet_oam ports
clear fdb
clear historical_counters ports
clear igmp_snooping data_driven_group
clear igmp_snooping statistic counter
clear log
clear mac_based_access_control auth_mac
clear mld_snooping data_driven_group
clear mld_snooping statistic counter
clear port_security_entry
clear vlan_counter statistics
CTRL+C ESC q Quit
When users enter a command without its required parameters, the CLI will prompt users with a Next possible completions:
message.
DAS-3626:admin#config account
Command: config account
Next possible completions:
<username>
DAS-3626:admin#
In this case, the command config account was entered with the parameter <username>. The CLI will then prompt users to enter
the <username> with the message, Next possible completions:. Every command in the CLI has this feature, and complex
commands have several layers of parameter prompting.
In addition, after typing any given command plus one space, users can see all of the next possible sub-commands, in sequential
order, by repeatedly pressing the Tab key.
To re-enter the previous command at the command prompt, press the up arrow cursor key. The previous command will appear at
the command prompt.
DAS-3626:admin#config account
Command: config account
Next possible completions:
<username>
DAS-3626:admin#config account
Command: config account
Next possible completions:
<username>
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
SPACE n Next Page
Figure 2-2. The ? Command
Figure 2-3. Example Command Parameter Help
Figure 2-4. Using the Up Arrow to Re-enter a Command
ENTER Next Entry a
4
All