D-Link DAS-3636 Cli Reference Manual page 14

create account
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create an administrator-level user account with the username "dlink".
DAS-3626:admin#create account admin dlink
Command: create account admin dlink
Enter a case-sensitive new password:****
Enter the new password again for confirmation:****
Success.
DAS-3626:admin#
config account
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the user password of "dlink" account:
DAS-3626:admin#config account dlink
Command: config account dlink
Enter a old password:****
Enter a case-sensitive new password:****
Enter the new password again for confirmation:****
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to create user accounts.
create account [admin | operator | user] <username 15>
This command is used to create user accounts that consist of a username of 1 to 15
characters and a password of 0 to 15 characters. Up to 8 user accounts can be created.
[admin | operator | user] <username 15>
Only Administrator-level users can issue this command.
Usernames can be between 1 and 15 characters.
Passwords can be between 0 and 15 characters.
NOTICE: In case of lost passwords or password corruption, please refer to the
"Password Recovery Command
Recovery Procedure" will guide you through the steps necessary to resolve this
issue.
Used to configure user accounts
config account <username>
When the password information is not specified in the command, the system will prompt the
user to input the password interactively.
<username> − Name of the account. The account must already be defined.
Passwords must have a minimum of 0 character and can have a maximum of 15 characters.
Only Administrator-level users can issue this command.
Usernames can be between 1 and 15 characters.
Passwords can be between 0 and 15 characters.
List" section in this manual, and the
9
"Password