Table of Contents
Advertisement
Command
show cfm mp_ltr_all
Each command is listed, in detail, in the following sections.
create cfm md
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a CFM maintenance domain.
DAS-3626:admin#create cfm md op_domain level 2
Command: create cfm md op_domain level 2
Success.
DAS-3626:admin#
config cfm md
Purpose
Syntax
Description
Parameters
Restrictions
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Parameters
Used to create a maintenance domain.
create cfm md <string 22> level <int 0-7>
Different maintenance domains should have different names.
md – Specifies the maintenance domain name.
level – Specifies the maintenance domain level.
Only Administrator and Operator-level users can issue this command.
Used to configure parameters of a maintenance domain.
config cfm md <string 22> {mip [none | auto | explicit] | sender_id [none | chassis |
manage | chassis_manage]}
Creation of MIPs on a MA is useful for tracing the link MIP by MIP.
It also allows the user to perform loop-back from MEP to an MIP.
md – Specifies the maintenance domain name.
mip – Specifies and controls the creation of MIPs.
none – Specifies that MIPs will not be created. This is the default value.
auto – MIPs can always be created on any ports in this MD, if that port is not configured with
a MEP of this MD.
For the intermediate switch in a MA, the setting must be auto in order for the MIPs to be
created on this device.
explicit – MIPs can be created on any ports in this MD, only if the existing lower level has an
MEP configured on that port, and that port is not configured with an MEP of this MD.
Only Administrator and Operator-level users can issue this command.
256
Advertisement
Table of Contents
