Table of Contents
Advertisement
DAS-3626:admin#show config current_config
Command: show config current_config
#------------------------------------------------------
#
#
#
Firmware: Build 1.00.B042
# Copyright(C) 2009 D-Link Corporation. All rights reserved.
#------------------------------------------------------
# STACK
# BASIC
# ACCOUNT LIST
# ACCOUNT END
# PASSWORD ENCRYPTION
disable password encryption
config serial_port auto_logout 10_minutes
enable telnet 23
enable web 80
CTRL+C ESC q
Quit
upload
Purpose
Used to upload the current switch settings or the switch history log to a TFTP.
Syntax
[ cfg_toTFTP [<ipaddr> |<ipv6addr>] <path_filename 64> | log_toTFTP [<ipaddr> |
<ipv6addr>] <path_filename 64> | attack_log_toTFTP [<ipaddr> |<ipv6addr>]
<path_filename 64> ]
Description
This command is used to upload either the Switch's current settings or the Switch's history
log to a TFTP server.
cfg_toTFTP − Specifies that the Switch's current settings will be uploaded to the TFTP
Parameters
server.
log_toTFTP − Specifies that the switch history log will be uploaded to the TFTP server.
attack_log_toTFTP – Specifies that the switch attack log will be uploaded to the TFTP server.
<ipaddr> − The IP address of the TFTP server. The TFTP server must be on the same IP
subnet as the Switch.
<ipv6addr> − The IPv6 address of the TFTP server.
<path_filename 64> − Specifies the location of the Switch configuration file on the TFTP
server. This file will be replaced by the uploaded file from the Switch.
Restrictions
The TFTP server must be on the same IP subnet as the Switch. Only Administrator and
Operator-level users can issue this command.
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
DAS-3600-12 Configuration
SPACE n
Next Page
ENTER
Next Entry
a
41
All
Advertisement
Table of Contents
