D-Link DAS-3636 Cli Reference Manual page 215

Example usage:
To show loop-detect ports:
DAS-3626:admin#show loopdetect ports 1-3
Command: show loopdetect ports 1-3
Port Loopdetect State
------ ------------------ ----------
1 Enabled
2 Enabled
3 Enabled
DAS-3626:admin#
config loopdetect trap
Purpose
Synta
x
Descr
iption
Para
meter
s
Restri
ction
s
Example usage:
To config loop trap both:
DAS-3626:admin#config loopdetect trap both
Command: config loopdetect trap both
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Loop Status
Normal
Normal
Normal
This command is used to config trap modes.
config loopdetect trap [ none | loop_detected | loop_cleared | both ]
The loop-detect trap is sent when the loop condition is detected. The loop-detect will be
cleared when the trap is sent and the loop condition is cleared.
none – Trap will not be sent for both cases.
loop_detected – Trap is sent when the loop condition is detected.
loop_cleared – Trap is sent when the loop condition is cleared.
both – Trap will be sent for both cases.
Only Administrator and Operator-level users can issue this command.
210