Table of Contents
Advertisement
config stp ports
Restrictions
Example usage:
To configure STP with path cost 19, hellotime set to 2 seconds, migration enabled, and state enabled for ports 1-5:
DAS-3626:admin#config stp ports 1-5 externalCost 19 hellotime 2 migrate yes state
enable
Command: config stp ports 1-5 externalCost 19 hellotime 2 migrate yes state enable
Success.
DAS-3626:admin#
create stp instance_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a spanning tree instance 2:
DAS-3626:admin#create stp instance_id 2
Command: create stp instance_id 2
Warning:There is no VLAN mapping to this instance_id!
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
STP must be globally disabled and 2. Forwarding BPDU must be globally enabled. To globally
disable STP, use the disable stp command, to globally enable fbpdu, use the config stp
command. The default is enable.
Only Administrator and Operator-level users can issue this command.
Used to create a STP instance ID for MSTP.
create stp instance_id <value 1-15>
This command allows the user to create a STP instance ID for the Multiple Spanning Tree
Protocol. There are 16 STP instances on the Switch (one internal CIST, unchangeable) and
the user may create up to 15 instance IDs for the Switch.
<value 1-15> − Enter a value between 1 and 15 to identify the Spanning Tree instance on the
Switch.
Only Administrator and Operator-level users can issue this command.
217
Advertisement
Table of Contents
