D-Link DAS-3636 Cli Reference Manual page 63

config limited_multicast_addr ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config port 1,3 to set the multicast address profile 2:
DAS-3626:admin#config limited_multicast_addr ports 1,3 ipv4 add profile_id 2
Command: config limited_multicast_addr ports 1,3 ipv4 add profile_id 2
Success.
DAS-3626:admin#
show limited_multicast_addr ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show a limited multicast address range:
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to configure the multicast address filtering function on a port.
config limited_multicast_addr [ports <portlist> | vlanid <vlanid_list>] {[ipv4|ipv6]}
{[add | delete] [profile_id <value 1-60> | profile_name <name 1-32> ] | access [permit |
deny]}
This command is used to configure the multicast address filtering function on a port. When
there are no profiles specified with a port, the limited function is not effective.
When the function is configured on a port, it limits the multicast group operated by the IGMP.
<portlist> − A range of ports to config the multicast address filtering function.
<vlanid_list> – A range of VLAN IDs to config the multicast address filtering function.
add − Add a multicast address profile to a port.
delete − Delete a multicast address profile to a port.
profile_id − A profile to be added to or deleted from the port.
profile_name <name 1-32> − The name of the profile.
permit − Specifies that the packet that match the addresses defined in the profiles will be
permitted. The default mode is permit.
deny − Specifies that the packet that match the addresses defined in the profiles will be
denied.
Only Administrator and Operator-level users can issue this command.
Used to show per-port Limited IP multicast address range.
show limited_multicast_addr {[ipv4|ipv6]} [ports {<portlist>} | vlanid <vlanid_list>]
This command allows you to show multicast address range by ports.
When the function is configured on a port, it limits the multicast groups operated by the IGMP
or MLD snooping function and layer 3 function.
<portlist> − A range of ports to show the limited multicast address configuration.
<vlanid_list> – range of VLAN IDs to show the multicast address configuration.
None.
58