Piper Arrow PA-28R-201 Pilot Operating Handbook page 234

ARROW
PA-28R-201,
827 CLEANING
(c) Cleaning ExteriorSurfaces (continued)
(2) Apply cleaning solution with a soft cloth, a sponge
softbristle brush.
(3) To remove
on the surface longer.
(4) To remove
with napbtha.
(5) Rinse allsurfaces thoroughly.
(6) Any good automotive wax may
surfaces.Soft cleaning cloths or a chamois should be used
to prevent scratches when
coating of wax
abrasion problems in these areas.
(d) Cleaning Windshield and Windows
(1) Remove
surfaceswith clean water.
(2) Wash
plastic cleaner.Use a
and forth motion. Do not rub harshly.
(3) Remove
kerosene.
Do
tetrachioride, thinner, acetone, or window
cleaning sprays.
(4) After cleaning plastic surfaces, apply
polishing wax. Rub
circular motion.
(5) A severe scratch or
rubbing
sides and apply wax.
12, 1995
ISSUED: JULY
HB-PQY, Page: 8-17-(0)
(continued)
exhaust stains, allow the solution to remain
stubborn oil and grease, use a cloth dampened
on the leading surfaces will reduce the
and other loose particles from exterior
dirt, mud
with mild soap and warm
oil and grease with a cloth moistened with kerosene.
CAUTION
not use gasoline, alcohol, benzene, carbon
lightly with a soft cloth. Do not
mar in plastic can be removed
otitthe scratch with jeweler's rouge. Smooth
IIAND!SERVIMAINT
be used to preserve painted
cleaning or polishing. A heavier
water or with aircraft
softcloth or sponge in a straight back
a thin coat of hard
REPORT:
Issued: JULY 12, 1995
SECTION 8
or a
use a
by rubbing
both
VB-1612
8-17