Piper Arrow PA-28R-201 Pilot Operating Handbook page 212

Hide thumbs Also See for Arrow PA-28R-201:
Table of Contents

Advertisement

ARROW
PA-28R-201,
7.39 EMERGENCY
NARCO
ELT 910 OPERATION
On the ELT
unit itself is a three position switch placarded ON,
ARM.
position sets the ELT
The ARM
will continue to transmit until its battery is drained. The ARM
selectedwhen the ELT
position.
A pilot's remote switch, placarded ON
side panel to allow the transmitterto be armed
cabin.The switch is normally in the ARM
will activate the transmitter. A warning light, located above the remote switch,
willblink continuously whenever the ELT
The warning
activated by an incident that also results in
severance of the airplane's power supply lines.
Should
the ELT
positioning the remote switch to the ON
relocating itto the ARM
and then back to ARM.
In the event the transmitteris activated by an impact, itcan be turned off
the ELT
by moving
resetting the switch to ARM.
the remote switch to the ON
position.
The transmittercan be activated manually at any time by placing either.the
remote switch or the ELT switch to the ON
should be checked during postflight to make
The ELT
not been activated Check by selecting 121.50 MHz
If a downward
sweeping audio tone is heard the ELT
Set the remote switch to ON.
you. Setting the remote switch back to ARM
*Optional Equipment
12, 1995
ISSUED:
JULY
HB-PQY, Page: 7-31-(0)
LOCATOR
TRANSMITTER*
so thatitwill transmit after impact and
is installedin the airplane and itshould remain in that
is activated.
NOTE
light will not blink if the ELT
be activated inadvertently it can be reset by either
position for two seconds, and then
position, or by setting the switch on the ELT
switch OFF. Normal
also be turned off and reset by positioning
It may
position for two seconds, and then to the ARM
If there is no change in the tone itis probably
Issued: JULY 12, 1995
DESCRJOPERATION
(continued)
and ARM,
is located on the left
or turned on from inside the
the switch to ON
position.Moving
is
operation can then be restored by
position.
certainthe unit has
on an operating receiver.
may have been activated.
will automatically resetthe ELT.
REPORT:
SECTION
7
OFF
and
position is
to OFF
VB-1612
7.31
7-31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents