Piper Arrow PA-28R-201 Pilot Operating Handbook page 211

SECTION 7
DESCRJOPERATION
7.39 EMERGENCY
NARCO ELT 10 OPERATION
To use the ELT
unlatch the unit from its mounting
by a left quarter-turn of the knurled nut and a pull. A sharp tug on the two
small wires will break them loose. Deploy
pulling the plastic tab marked
Move the switch to ON
In the event the transmitter is activated by an impact, itcan only be turned
the switch on the ELT
off by moving
be restored by pressing the small clear plastic reset button located on the top
of the front face of the ELT
A pilot's remote switch located on the leftside panel is provided to allow
the transmitter to be turned on from inside the cabin. The
switch is placarded
ARMED
position. Moving
the switch back to the ARMED
Moving
only ifthe impact switch has not been activated.
The ELT should
activated during the ground
operating receiver. If there is an oscillating chirping sound,
have been activated and should be turned off immediately. This requires
removal of the access cover and moving
reset button and return the switch to ARM.
ascertain the transmitter is silent.
*optional Equipment
REPORT: VB-1612
7-30
HB-PQY, Page: 7-30-(0)
LOCATOR TRANSMITTER*
(continued)
as a portable unit in an emergency, remove
base. The antenna cable is disconnected
PULL FULLY
to activatethe transmitter.
unit to OFF. Normal
and then moving
and ARMED.
ON
the switch to ON
be checked to make
check. Check
PA-28R-201,
(continued)
the self-contained antenna by
TO EXTEND
operation can then
the switch to ARM.
The switch is normally
will activate the transmitter.
position will turn off the transmitter
certain the unit has not been
by selecting 121.50 MHz
the switch to OFF, then press the
Recheck with the receiver to
ISSUED:
Issued: JULY 12, 1995
ARROW
the cover and
ANTENNA.
pilot's remote
in the
on an
the ELT
may
12, 1995
JULY
7-30