Aileron Linkage - Seagull Models ET 6 - TEXAN Assembly Manual

ET6.

AILERON LINKAGE.

1) Using a ruler & pen to draw a straight
line as below picture.
2) Locate the two nylon control horns, two
nylon control horn backplates and four
machine screws.
3) Position the aileron horn on the bottom
side of aileron. The clevis attachment holes
should be positioned over the hinge line.
2mm X 20mm.
Mounting Screws.
4) Using a 1mm drill bit and the control
horns as a guide, drill the mounting holes
through the aileron halves.
5 Mount the control horns by inserting the
)
screws through the control horn bases and
aileron halves, then into the mounting
backplates. Do not overtighten the screws or
the backplates may crush the wood.
6) Connect the linkage as shown and se-
cure the control wire with a wire keeper.
8
Straight line.
Control Horn.
Mounting Plate.
Instruction Manual.
Pen.
Cut
.
Wire keeper.
Servo arm.