Installing The Battery; Cowling Installation - Seagull Models ET 6 - TEXAN Assembly Manual

INSTALLING THE BATTERY.

See pictures below.
Tie wrap or rubber band.
Battery.

COWLING INSTALLATION.

1) Using a pen to mark the points follow-
ing the instruction below.
Cowling.
www.seagullmodels.com
Speed control.
Dummy engine.
Silicon glue or C/A glue.
2) Slide the fiberglass cowl over the en-
gine and line up the back edge of the cowl with
the marks you made on the fuselage then trim
and cut.
3) While keeping the back edge of the
cowl flush with the marks, align the front of
the cowl with the crankshaft of the motor. The
front of the cowl should be positioned so the
crankshaft is in nearly the middle of the cowl
opening. Use the spinner backplate as a guide.
Hold the cowl firmly in place using pieces of
masking tape.
4) Slide the cowl back over the motor.
Glue.
13