Wing Assembly - Seagull Models ET 6 - TEXAN Assembly Manual

ET6.
Landing gear wire.
3 x 10mm.
INSTALLING THE GEAR FAIRING.
See pictures below :
6
NOTE: We highly recommend using 30
minute epoxy as it is stronger and provides
more working time, allowing the builder to
properly align the parts. Using fast cure epoxy
when joining the wing halves could result in the
glue drying before the wing halves are aligned
properly which may result in failure of the wing
centre section during flight.
1) Coat both sides of one half of the dihedral
brace with 30 minute epoxy. Next, pour some
epoxy into the dihedral box in one wing panel.
. Use enough epoxy to fill any gaps.
Wing brace.
Gear faring.
Plastic trap.
2) Carefully slide the two wing halves together
and firmly press them together, allowing the
excess epoxy to run out. There should not be
any gap in the wing halves. Use rubbing
alcohol and a paper tower to clean up any
excess epoxy.
C/A glue.
hold the wing halves together securely.
Instruction Manual.

WING ASSEMBLY.

Epoxy.
3)Apply masking tape at the wing join to
Wing brace.