Hinging The Rudder; Installing The Main Gear Wires - Seagull Models ET 6 - TEXAN Assembly Manual

Glue the elevator hinges in place using the
same tectniques used to hinge the ailerons.

HINGING THE RUDDER.

Glue the rudder hinges in place using the
same tectniques used to hinge the ailerons.

INSTALLING THE MAIN GEAR WIRES.

1) Assemble and mounting the wheel as
shown in the following pictures.
Collar.
www.seagullmodels.com
C/A glue.
Landing gear.
2) Using a modeling knife, remove the
covering from over the two main gear mount-
ing slots located in the bottom of the wing.
3) Insert the 90º bend of one main gear
wire into the predrilled hole in one mounting
slot.
Wing bottom.
Gear mounting slot.
Wing bottom.
Landing gear wire.
4) The landing gear wire is held in place
using two nylon landing gear straps and four
3mm x 10mm wood screws.
5