Installing The Aileron Linkage - Seagull Models MUSTANG P-51 Assembly Manual

MUSTANG P-51.
AILERON LINKAGE.

INSTALLING THE AILERON LINKAGE.

1) Using a ruler & pen to draw a straight
line as below picture.
Straigh line.
2) Locate the two nylon control horns, two
nylon control horn backplates and two machine
screws.
2mm x 20 mm.
8
Plastic tape.
Pen.
Servo arm.
Instruction Manual.
3) Position the aileron horn on the bottom
side of aileron. The clevis attachment holes
should be positioned over the hinge line.
Mounting Screws.
4) Using a 1mm drill bit and the control
horns as a guide, drill the mounting holes
through the aileron halves.
5 Mount the control horns by inserting the
)
screws through the control horn bases and
aileron halves, then into the mounting
backplates. Do not overtighten the screws or
the backplates may crush the wood.
6) Thread one adjustable control horn onto
each aileron control rod. Thread the horns on
until they are flush with the ends of the control
rods.
Control Horn.
Mounting Plate.