Seagull Models ET 6 - TEXAN Assembly Manual page 14

ET6.
The propeller should not touch any part
of the spinner cone. If it does, use a sharp
modeling knife and carefully trim away the
spinner cone where the propeller comes in
contact with it.
5) Secure the cowl with the screw pro-
vide with hardware.
Wood screw.
INSTALLING CANOPY.
See pictures below.
Glue.
Screw.
14
3mmx10mm
2mm x 8mm.
anced correctly. Improper balance will cause
your plane to lose control and crash. The cen-
ter of gravity is locate
the leading edge of the wing, measured at wing
tip.
Glue.
Instruction Manual.
ATTACHMENT WING - FUSELAGE.
Bolt the wing to fuselage.
Wing.
Fuselage.
BALANCING.
1) It is critical that your airplane be bal-
2 - 4.5cm
Glue.
Wing bolt.
2 - 4,5 cm.
back from