Seagull Models ET 6 - TEXAN Assembly Manual page 7

4) When the epoxy has cured, carefully
remove the masking tape from the wing.
5) Peel off the backing from the self adhe-
sive covering strip. Apply the strip to the centre
section of the wing starting from the bottom
trailing edge. Wrap the strip all the way around
the wing until it meets the trailing edge again.
Trim off any excess strip.
C/A glue.
AILERON SERVOS-LINKAGES.
1) Turn the wing panel right side up. Using
a modeling knife, remove the covering at servo
tray.
Install the rubber grommets and brass collets
onto the aileron servo.Test fit the servo into
the aileron servo mount.
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of
the mount allow the servo lead to pass through.
Attach the thread to the servo lead and
carefully thread it though the wing.
Small weight.
www.seagullmodels.com
Thread.
Servo mount.
Wing bottom.
Servo electric wire.
Electric wire.
2)Secure the servos with the screws pro-
vided with your radio system.
Wing bottom.
Thread.
Small weight.
Thread.
Plastic tape.
7