Installing The Aileron Linkage - Seagull Models EXTRA 260 Instruction Manual

EXTRA 260.

INSTALLING THE AILERON LINKAGE.

3x45mm.
! 1) Aileron control horn:
Mix a small amount of 30 minute epoxy and
lightly coat the inside of the hole in the aileron
and the control horn screw.
Wing.
! 2) Thread the screw (insert the aluminium
washer) into the hole from the top of surface.
Wipe away any excess epoxy on the wing and
screw with rubbing alcohol and a paper towel.
Screw the M3 nut (insert the aluminium
washer) in place as shown. Alllow the epoxy
to fully cure.
12
C/A glue.
Aileron.
Instruction Manual.
M3 lock nut.
M3 nut.
Aileron control horn.
Repeat the procedure for orther wing.
ELEVATOR CONTROL HORN INSTALLATION.
!
1) Elevator control horn:
Mix a small amount of 30 minute epoxy and
lightly coat the inside of the hole in the elevator
and the control horn screw.
Horizontal fin.
! 2) Thread the screw (insert the aluminium
washer) into the hole from the top of surface.
Wipe away any excess epoxy on the fin and
screw with rubbing alcohol and a paper towel.
Screw the M3 nut (insert the aluminium
washer) in place as shown. Alllow the epoxy
to fully cure.
Elevator control horn.
Wing bottom.
M3 control horn.
Aluminium washer.
Wing bottom.
.
Elevator