Final Assembly - Hangar 9 Twin Otter ARF Assembly Manual

Step 2
Use double-sided foam tape to attach the battery
to the left-hand side of the radio tray in the upper
fuselage. You may choose to mount the battery in the
nose section if required for balancing.
Step 3
Use double-sided foam tape to attach the receiver to
the radio tray.
38
Step 4
Mount the remote receiver in your desired location
using double-sided foam tape. It is shown here on the
right-hand fuselage side below the wing tube.
Step 5
Connect the necessary extension leads and
Y-harnesses to the receiver. Use the equipment list on
page 4 as a guide for making these connections.
We recommend securing the elevator servo extension
leads within the fuselage so that they cannot become
entangled with the rudder cables.

Final Assembly

Parts Required
Fuselage Wing panels (left and right)
Wing tube Wing struts
Rear fuselage hatch Top fuselage hatch
Stabilizer tube
8-32 x 1-inch Allen head machine screws
#2 x 1/4-inch woodscrews (10)
1/4-20 x 2-inch nylon wing bolts (2)
Tools Required
3/32-inch hex wrench 1/8-inch hex wrench
Pin vise 1/16-inch drill bit
Pencil #1 Phillips screwdriver
Thin CA
Step 1
Set the rear fuselage hatch in place and mark the
mounting holes with a pencil.
Twin Otter ARF Assembly Manual