Final Assembly - Hangar 9 Pulse 125 Assembly Manual


Step 4
Slide the spinner backplate over the propeller adapter. It
may be necessary to enlarge the hole in the center of the
spinner backplate using a tapered reamer so it will fit on the
propeller adapter.

Step 5
Slide the propeller on the propeller adapter. The small
standoffs on the spinner backplate will help in aligning the
propeller.
32
note: It may be necessary to enlarge the hole in the
center of the propeller using a tapered reamer so it will
fit on the propeller adapter.
important: Always balance your propeller right before
mounting it to prevent vibrations that could damage the
airframe or motor bearings.

Step 6
Secure the propeller using a box wrench and the hardware
from the adapter.

Step 7
Secure the spinner cone to the backplate using two 3mm x
10mm self-tapping screws.

Final Assembly

Required Parts
Fuselage Canopy
Wing panel (left and right) Wing bolt plate
Aluminum wing tube
6mm x 40mm nylon wing bolt (2)
Tools and Adhesives
Canopy glue Medium grit sandpaper
Paper towel Rubbing alcohol
Low-tack tape

Step 1
Use medium grit sandpaper to lightly sand the inside edge
of the canopy where it contacts the fuselage. Use a paper
towel and rubbing alcohol to remove any oil or debris after
sanding. Apply a thin bead of canopy glue to the inside edge
of the canopy. Use low-tack tape to hold the canopy securely
on the fuselage until the glue fully cures.
Hangar 9 Pulse 125 ARF Assembly Manual