Section 9: Final Assembly - Hangar 9 FuntanaX 100 ARF Assembly Manual

Section 9: Final Assembly

Required Parts
• Side force generator (2)
• Hatch
• 4-40 x 1/2" screw (8)
• Decals
• #2 x 1/2" sheet metal screw (2)
Required Tools and Adhesives
• Plywood
• Hobby knife
• Radio switch harness
• Shoo Goo
• Hex wrench: 3/32"
• Drill bit: 3/32" (2.5mm)

Step 1
Wrap the receiver and receiver battery in protective foam
to prevent damage that may be caused by engine vibration.
Attach the battery and receiver to the plywood tray.
• Fuselage
• Canopy
• #4 washer (8)
• Pilot
• Medium CA
• Receiver
• Receiver battery
• Masking tape
• Drill
• Canopy glue

Step 2
Secure the radio tray into the fuselage using two
#2 x 1/2" sheet metal screws. It may be necessary to
shift the battery forward or aft to balance the model as
described in the section "Center of Gravity." Plug in
any servo leads or extensions at this time and connect
any extensions necessary for the aileron servos.
33