Christie roadie 25k User Manual page 79

Editing a Channel Setup
CHANNEL EDIT — STEP 1
CHANNEL EDIT — STEP 2
CHANNEL EDIT — STEP 3
'
The basic setups that describe how and where a channel can be accessed are listed in
the Channel Setup menu. These channel setups can be edited at any time in the
Channel Edit submenu.
From the presentation level press
Channel Setup menu, press
and press Enter . The Channel Setup menu will appear.
To edit parameters shown in the Channel Setup menu, select the relevant channel and press
Enter . The Channel Edit menu will appear similar to the sample shown in Figure 3.14.
If desired, review and/or edit the following channel setups in the Channel Edit menu:
•
CHANNEL NAME:
here. Channel names can be up to 12 characters in length.
•
CHANNEL NUMBER:
NOTES: 1) If you enter a channel number that already exists, a dialog
message appears indicating that this number is already in use–assign a
different channel number. 2) You can define up to 99 channels.
•
1-8, corresponding to where on the projector's input panel the
INPUT:
source is connected.
•
IN MENU:
with unchanged parameters), this defined channel will then appear in the
list available when
accessed via
On-screen display of the channel list is an option that must be set in the
Menu Preferences menu.
•
AUTO SOURCE:
locate this channel when an incoming input signal matches. If not
checked, the projector can locate the selected channel only when it is
directly selected via
not result in a channel change.
•
LOCKED:
If unchecked (default), all available image settings can be adjusted as
desired. You cannot use Auto Setup with a locked channel.
•
PREVIOUS CHANNEL:
settings for the previous channel in the Channel Setup list.
Menu to display the main menu. To display the
, or move the highlight to the Channel Setup option
Figure 3.14. Channel Edit Menu (
An alpha-numeric label can be defined and/or changed
A 2-digit channel number can be changed here.
If checked (default, except for automatically defined channels
Chan key is pressed. If unchecked, the channel must be
Chan on the keypad or via the Auto Source function. NOTE:
If checked, (default), the projector can automatically
Chan on the keypad—and a change in input signal will
If checked, all of the image settings for this channel are disabled.
Select this option to see or change Channel Edit
OPERATION
SAMPLE
)
Roadie 25K User's Manual
3-23