Christie roadie 25k User Manual page 30

INSTALLATION AND SETUP
RGB Signals
2-24
Roadie 25K User's Manual
'
consists of 5 BNCs
INPUT 1
(connectors) for linking to a variety of
sources. The typical connection would
be to an RGB source such as a PC,
Mac, DEC, Sun, SGI and others. This
projector supports multiple sync types
with RGB signals: sync-on-green,
composite sync, and separate H & V
syncs.
NOTE: Depending on your source,
you may need a custom adapter cable
with BNC connectors at the projector
end and a different type of connector
at the other (such as a 15-pin "D"
connector for some computer
sources). Contact your dealer for
details.
Connect the BNC input(s). Then
SYNC
connect the red, green and blue source
outputs to the ,
RED
BNCs on the
INPUT 1
source uses sync-on-green, only the
red, green, and blue connections are
required. If the source provides a
composite sync output, connect it to
the input labeled
SYNC
the source provides separate horizontal
and vertical sync outputs, connect
horizontal sync to the
labeled
HOR/COMP
vertical sync to
SYNC
NOTES: 1) If for some reason the projector fails to recognize a signal as an RGB
signal, specify this Color Space option within the Image Settings menu. See 3.7,
Adjusting the Image. 2) To connect YPbPr signals–such as from DVDs or analog HDTV
INPUT 1
sources–to , use the red, green and blue BNCs as described in YPbPr Signals
(below). 3) This input does not route to the decoder and cannot be used for Composite
Video or S-Video.
, and
GREEN BLUE
panel. If the
. If
HOR/COMP
input
SYNC
and connect
input labeled See Figure 2.26.
VERT.
Figure 2.26. Connecting an RGB
Source