Christie roadie 25k User Manual page 141

STEP 16
Filter Replacement
Procedure
BEFORE YOU BEGIN
STEPS 1-2
STEPS 3-4
STEPS 5-6
LampLOC ensures maximum brightness, with the lamp well-centered with its
reflector and distanced correctly from the rest of the illumination system. Refer to
3.10, Working with the Lamp for details.
'
Record the serial number of the new lamp
1. In the Lamp menu, select "Change Lamp".
2. In the Lamp S/N text box, enter the serial number.
3. Press
and to reset the lamp timer. The timer will now begin to log time for the
new lamp.
'
Replace the air filter whenever the lamp module is replaced, or more frequently if
operating the projector in a dusty or dirty environment. Check monthly in all cases.
The filter is located on the lamp side of the projection head, near the front.
See Figure 4.4.
'
Power down and disconnect from AC
Follow steps 1-3 from the Lamp Replacement Procedure, above.
'
Open/remove filter door
Loosen 2 corner screws (flat screwdriver), and lift off door.
'
Replace air filter
Slide the old filter down-and-out and discard. Insert the new air filter, following the
labeling for proper inside/outside orientation. Slide all the way up, under top tabs.
'
Close/replace filter door
With the filter in place, insert the bottom tabs of the filter door into the corresponding
slots, close the filter door, and secure with 2 screws.
(or on the standard remote keypad) to record the number
Enter
WARNING
Use only Christie filters. Never operate
the projector without the filter installed.
MAINTENANCE
Roadie 25K User's Manual
4-11