Christie roadie 25k User Manual page 55

•
Plug the keypad cable (supplied) into the empty battery compartment.
Pack with foam as an internal strain relief. Make sure that the battery
cover is notched smoothly to accommodate the cable without pinching it.
•
Set keypad protocol to "wired" jumper setting (refer back to Figure
2.53). Make sure to set jumper #4 between pins 2 and 3 as shown in the
last example (shaded).
•
Replace battery compartment cover.
•
Plug into the 3-pin XLR port at the rear panel of the projector.
TO CHANGE FROM WIRED TO INFRARED:
•
Unplug the keypad from the projector.
•
Open the keypad back and unplug the keypad cable.
•
Wait 1-2 minutes.
•
Install batteries (see Section 4).
•
Set jumpers according to the desired IR protocol (refer back to Figure
2.53). Make sure to set jumper #4 between pins 1 and 2 as shown for all
remote protocols.
•
Replace battery compartment cover.
INSTALLATION AND SETUP
Roadie 25K User's Manual
2-49