Christie roadie 25k User Manual page 65

Chan Channel
Press to select a specific source setup (channel) defined and stored in projector
memory. Once you enter a 2-digit channel number (or, if there is a list displayed,
highlight it and press
according to the numerous setup parameters defined for that channel. Note that a new
channel is automatically created if you adjust animage from a new source.
NOTE: key behavior during a presentation depends on whether or not the
Chan
Display Channel List option is enabled in the Menu Preferences menu. You can
choose to use a scrollable list of channels when you press
enter the desired channel number "blind", i.e., without on-screen feedback. See
Menu Preferences later in this section.
Input 1
Input 1
Press to display from the data input source connected to BNCs labeled
Input 1
If PIP is enabled, pressing this key will change the PIP source.
Input 2
Input 2
Press to display from the DVI source (analog or digital) connected to
Input 2
PIP is enabled, pressing this key will change the PIP source.
Input 3
Input 3
Press to display from the composite video source connected to
Input 3
enabled, pressing this key will change the PIP source.
Input 4
Input 4
Press to display from the S-video source connected to
Input 4
enabled, pressing this key will change the PIP source.
Input 5
Input 5
Press to display from the
Input 5
which is typically the standard factory-installed Dual SD/HD-SDI Module. If PIP is
enabled, pressing this key will change the PIP source.Note that if there are two inputs
connected to this module, the second input (B) is considered
easily accessed with
"lite" remote keypad, neither of which have a separate
INPUT 7
access as follows:
•
While displaying from
•
While displaying from any input other than the Dual SD/HD-SDI Module,
press . This switches to either
Input 5
the Dual SD/HD-SDI Module inputs (A or B) was last used. Press
to display from the other Dual SD/HD-SDI Module input.
Input 6
Input 6
Press to display from the
Input 6
If PIP is enabled, pressing this key will change the PIP source. If the Dual SD/HD-
SDI Module is installed here, and there are two inputs connected, its second input (B)
INPUT 8
is considered
), the display will automatically change and update
INPUT 5
interface module installed in the Option 1 slot,
. Or, if you are using the built-in keypad or the optional
Input
INPUT 5
, press
INPUT 5
INPUT 6
interface module installed in the Option 2 slot.
and can be most easily accessed with
, or you may prefer to
Chan
INPUT 3
INPUT 4
. If PIP is
INPUT 7
INPUT 5
key, use
Input
again. This switches to
Input 5
INPUT 7
or , depending on which of
. Or, if you are
Input
Roadie 25K User's Manual
OPERATION
INPUT 1
.
INPUT 2
. If
. If PIP is
and can be most
to
INPUT 7
.
again
Input 5
3-9