Christie roadie 25k User Manual page 149

DVI-I
(INPUT 2)
Interface standard
Signal types / color spaces
Pixel clock rate
Analog sync input impedance
Maximum cable length
Supports EDID and HDCP
For all other DVI specifications, see Analog: RGB / YPbPr on previous page.
Dual SD/HD-SDI
Number of inputs
Connector type
Supported interface standards
Signal types / color spaces
Pixel clock rates supported
'
Control Wired Remote Keypad
2 inputs on projection head
Input levels
Voltage output
Current output
Cable length
IR Remote Keypad
Number of IR sensors on projector
Wavelength of peak sensitivity
Modulation (carrier) frequency
Encoding method
Range
Assumes no fluorescent lighting interference.
If range appears limited, shield the IR sensor, turn off lights, or change your fluorescent ballast.
Ethernet
Number of ports
Standard
Connector type
Max. baud rate
RS232 Serial Input
Number of connectors
Connector type
Max. baud rate
(INPUT 5 or 6, STANDARD WITH PROJECTOR)
(CONVERTED FROM IR REMOTE KEYPAD)
SPECIFICATIONS
DDWG DVI 1.0
•
RGB (digital or analog)
•
YPbPr (analog)
•
YCbCr (digital)
not supported in v1.1 s/w
25 – 165 MHz
1 kS
5 meters (16 ft.)
2, each with active loop-through
BNCs, 75S
SMPTE 259M
(13.5 MHz clock modes only)
SMPTE 292M
Serial digital YCbCr
(4:2:2 only)
13.5 MHz, 74.25 MHz, 74.25/1.001 MHz
• 3-pin XLR connector (rear)
• 3.5mm phono jack (side)
• High = 2.2 V – 5.6 V (or open)
• Low = -0.6V – 0.9V @ 1mA
+5VDC ±5%
100 mA nominal, 250 mA max.
25 ft.
2 (front and rear)
950 nm
36 kHz (nominal)
bi-phase
100 ft.
1
100Base-TX
RJ-45
115200
2
9-pin subminiature D (female=in,
male=out)
115200
Roadie 25K User's Manual
6-3