Christie roadie 25k User Manual page 53

INSTALLATION AND SETUP
NOTE: Matching the protocol on the projector to that of a keypad is done through a
setting in the Communications submenu. See 3.8, Adjusting System Parameters and
Advanced Controls for further information on how to define which protocol the
projector's infrared sensors (rear and front) will recognize.
Figure 2.51. Independent Keypads and Projectors
'
The Roadie 25k's standard IR remote keypad can be set to one of seven different
Remote Keypad
Protocols
protocols, "A" through "G". To change protocol in the remote, follow Steps 1
through 4.
NOTE: Protocols B-G are not supported in v1.1 software. Use "A" or "Wired" only,
both of which can be turned on or off.
Step 1
Unlatch and open the battery compartment on the back of the keypad as shown in
Figure 2.52.
Figure 2.52. Opening the Remote
Step 2
Find the 4 jumpers located along the latching side of the battery compartment. These
jumper settings establish the remote keypad protocol so that the remote functions in a
certain manner.
2-47
Roadie 25K User's Manual