Christie roadie 25k User Manual page 72

OPERATION
Time-outs
The Global Icon
The PIP Icon
Using Slidebars and
Other Controls
3-16
Roadie 25K User's Manual
'
If a slidebar, menu, or message is displayed, you have limited time in which to make
a keypad entry before the projector returns to presentation level
disappears. These time-outs may vary depending on what is displayed.
'
Menu options that include this icon apply universally to any incoming signal.
'
Menu options that include this icon apply to PIP (secondary) images only.
'
Most of the function menus allow you to change settings by using slidebars,
checkboxes, and pull-down lists. To select a slidebar, toggle a checkbox status, or
view a pull-down list, do one of the following within the function menu:
•
Enter the menu option number corresponding to the setting you wish to change
(for example, press
menu).
•
Or move the highlight to the option desired and press
•
Or move the highlight to the option desired and press
immediately.
•
Or bypass the menus entirely and use a single key to immediately access an
adjustment during your presentation (NOTE: applies only to options having
their own key, such as Contrast, Brightness, Gamma, etc.).
•
For "blind" access, hide the entire menu system (see OSD key, above) and/or
direct slidebars activated by their own key (such as Contrast, Brightness, etc.).
Control by using the proper keypress or numerical sequence of key presses.
Once selected, change the setting as desired (see below). Changes take effect
immediately and are saved upon exit from all menus, or after 15 minutes.
Slidebars in menus –
such as size or vertical stretch, appears to the left of its slidebar
icon (adjustment window). This number often expresses a percentage, or it may have
units associated with it (such as pixels, degrees Kelvin, etc.), depending on the
specific option. Press
number and the length of the bar change accordingly. Hold for continuous
adjustment. Or press
the keypad, then press
"Direct" slidebars -
slidebars without traveling the menu system. For example, simply press
Figure 3.8. Accessing General Help Topics
1 3 to select Vertical Stretch in the Size & Position
The current value for a given parameter,
to gradually adjust the setting up or down—both the
to activate a slidebar text box for specific number entry via
to save (or press
For quick access, you access Gamma, Brightness, and Contrast
and the graphic
Help
(Enter).
Exit to cancel).
to adjust
Cont
to