Christie roadie 25k User Manual page 58

OPERATION
3-2
Roadie 25K User's Manual
in dusty/dirty environments. Check condition monthly. See 6.4, Replacing the Lamp
& Filter for complete instructions.
Ballast Breaker (on/off)
The breaker on the lamp ballast serves two purposes: 1) it is a power switch for the
Roadie 25K ballast 2) it protects against over-current conditions of 50A or more. The
breaker must be ON in order to enable normal Roadie 25K system power-up and
operation. If faulty or major excessive AC is detected, the breaker will "trip" to OFF
in order to prevent damage. Try moving the breaker ON again—if the breaker
continues to trip OFF, this indicates a major fault and the AC problem must be
resolved. Possible causes might include shorts, damage to lamp cables, or very
excessive AC.
NOTE: This switch does not power up the projector or start the lamp. You must press
(POWER) on the keypad.
The ballast's internal fan indicates whether or not the breaker/switch is on. There is
no other indicator. Lights on the ballast indicate only that the ballast is plugged in.
Channels for FredFrame
Adjustment mechanisms (part of Christie's FredFrame
channels under the projector, enabling the projector to be hoisted, flown, and/or
stacked. Consult complete installation instructions supplied with the frame kit.
(REAR OF PROJECTOR)
Control Panel
The rear control panel includes the built-in keypad, IR sensor, 2-digit error code
window, and the LCD status display.
BUILT-IN KEYPAD:
with the projector. For more convenient functionality, use a remote or a serial
message-based method of control.
IR SENSOR:
Detects commands from the IR remote keypad. A second IR
sensor located on the front of the projector can also detect IR commands
reflected from the screen.
2-DIGIT STATUS / ERROR CODE WINDOW:
the basic operational state of the projector. Codes are translated in the LCD
Status Display window, and are listed at the end of Section 3.
LCD STATUS DISPLAY:
Figure 3.2. Control Panel
Provides access to all software controls needed for working
The code appearing here indicates
Full status and error messages appear in this window.
)
insert and secure into these