Christie roadie 25k User Manual page 63

'
With the addition of a cable (supplied) and with proper internal jumper settings, the
Wired Remote
IR remote converts into a wired remote keypad which connects to the 3-pin XLR jack
via a 100 ft. cable. The wired remote is recommended when:
Change the jumper settings to "Wired" (see Section 2.14). Upon plug-in to the
projector, enable the "Wired Keypad" checkbox in the Communications menu.
NOTE: A smaller "lite" wired remote is available as an option. It has only one
protocol, thus needs no change in jumper settings, and connects via RCA connector
to the input panel on the side of the projector. Commands from this keypad have
Figure 3.5. Standard Remote Keypad
•
the rear built-in keypad is inaccessible
•
the lighting conditions are unsuitable for proper IR transmission
OPERATION
Roadie 25K User's Manual
3-7