Christie roadie 25k User Manual page 129

System Warnings
A system warning indicates that a system malfunction has been detected (see Status
LED Codes, below). A system warning message replaces any input signal message
and disappears when the input signal status changes. While the projector will remain
operational, the message indicates the presence of a potentially serious problem that
should be reported to the manufacturer. You can press
message, but for best results you should reset the projector—power the projector
down and up again with the
System Errors
A system error message indicates that a serious malfunction has been detected and
must be reported to the manufacturer as soon as possible (see Status LED Codes,
below). The projector will no longer operate and must be reset—power the projector
down and up again with the
The Status LED Codes
If the status code display on the back of the projector shows one of the following
values, you have encountered a likely system error requiring the attention of a
qualified service technician (see System Warnings and System Errors, above).
Acknowledge and clear the error with
resetting the projector by powering it off and on again, cooling when necessary.
Consult Table 3.6 and contact your dealer if the problem persists.
The specific code number identifies the source of the error detected, and is
particularly useful in cases where the projector is too far away to read the
accompanying text message in the LCD status display window. For example, the
code "27" means the lamp could not be turned on. Error codes for this projector are
listed in Table 3.6.
(power) key.
(power) key.
Exit Exit from presentation level, or try
Roadie 25K User's Manual
OPERATION
Exit to remove the
3-73