GGP ITALY SPA P680 Operator's Manual page 31

EN 14
2. Fuel filter
1. Using a wire hook, take out the filter from the
filler port.
2. Disassemble the filter and wash with gaso-
line, or replace with a new one if needed.
NOTE
• After removing the filter, use a pinch to hold
the end of the suction pipe.
• When assembling the filter, take care not to
allow filter fibers or dust inside the suction
pipe.
3. Oil tank
Drain the oil tank and clean the inside with gaso-
line.
4. Spark plug
Clean the electrodes with a wire brush and reset
the gap to 0.65 mm as necessary.
5. Sprocket
Check for cracks and for excessive wear inter-
fering with the chain drive. If the wear is consid-
erable, replace it with new one. Never fit a new
chain on a worn sprocket, or a worn chain on a
new sprocket.
6. Front and Rear dampers
(1) Weight
Replace if adhered part is peeled or crack is
(2) Filter
observed on the rubber part. Replace if the
(3) Strainer
inside of the rear damper metal has been beaten
(4) Retainer
by the stopper bolt and the clearance of the
metal increased.
Champion
RCJ-7Y
7. Maintenance