Fuji Xerox DocuPrint CM415 AP User Manual page 61

No. Component
8 Drum cartridges
9 Waste toner container
10 Main power switch
11 Side cover
12 Output tray
13 Tray 5 (bypass tray)
14 Tray 1 and 2
15 Toner cartridges
16 Front cover
 Left side and rear views of the machine
12
11
10
9
8
No. Component
1 USB 2.0 interface connector
2 PHONE connector
3 LINE connector
4 USB 2.0 interface connector
5 10BASE-T/100BASE-TX
connector
6 Security slot
Contains photoconductors.
Collects waste toner.
Switches the main power on/off of the machine. Always follow the
instructions by the system administrator.
Important • Always switch the power off before switching the main power off. Refer
to "Power Source" (P.63).
Open this cover to replace consumable and clean the machine.
Copies and prints are delivered here.
Used for loading non-standard paper, such as thick-stock paper and other
special media, that cannot be loaded in Trays 1 and 2.
Load paper here.
Note • Tray 2 is optional.
Contains toner.
Open this cover to replace consumable and clean the machine.
Connects to a USB memory device.
Enables you to connect the machine to a telephone device.
Do not connect any device (fax system) other than a telephone.
Use this connector to connect to a telephone line.
Note • ISDN is not supported.
Connects to the 3Gnet-BOX (optional).
Connects to a network cable. To use this as a Gigabit Ethernet interface
connector (1000BASE-T), install the Gigabit Ethernet Kit (optional).
The Kensington lock (optional) can be attached to the machine.
Machine Components
Function
Function
*
*
2
1
2
3
4
5
6
7
61