Fuji Xerox DocuPrint CM415 AP User Manual page 143

 Delete
Clears the document data stored by the Build Job feature, and cancels the job.
Note
 Last Original
Select this button to end scanning of documents. The build job starts.
 Next Original
Select this button when you have another document. This button is always selected when
you use the Build Job feature.
 Start
After loading the next document, select this button to scan the next document.
Note
 Sample Job
When making multiple sets of copies, you can print a sample set to check the finished output
and then print the remaining copy sets. You can select to continue or cancel the job after
the confirmation.
[Build Job - Chapter Start] Screen
This screen allows you to set the chapter start.
1
Select any option.
 Off
The next stack of documents is copied after the
previous stack.
 On
The next stack of documents is copied from Side
1 of a new sheet of paper.
 Pages per Side - New Page
When [Pages per Side] is set, even if all documents are divided for every chapter before all
of them are assembled in the Pages per Side feature, the next stack of document is copied
from Side 2 of the paper.
[Segment Separators] Screen
This screen allows you to insert a sheet of paper as a separator in between each stack of
documents. You can specify the number of separators to insert in the range from 1 to 99 as
necessary.
Note
• You can also press the <C (Clear)> or <Clear All> button on the control panel to perform the same
operation.
• While the machine is scanning the loaded document, [Delete] is displayed. Select [Delete] to pause
scanning. Select [Start] on the touch screen, or press the <Start> button on the control panel to
resume scanning.
• You can also press the <Start> button on the control panel to perform the same operation.
• You can specify different settings for each stack of documents. If you do not specify particular
settings for each stack of documents, the previously specified settings are applied.
Job Assembly
3
143