Fuji Xerox DocuPrint CM415 AP User Manual page 219

DTMF Method
The following two types are available in the DTMF method: Auto Send and Manual Send.
 Auto Send (Transmitting without picking up the receiver)
1
Select the keyboard button to display the keyboard on the touch screen and enter in the
following format.
Relay station
telephone
number
 Password
A pre-registered two-digit number
Note
Relay station ID

The last two digits of the initiating station address number registered at the relay station
 Address number
An address number for the relay recipients registered at the relay station
The wildcard "*" can also be used.
You can register the above dialing format in an address number to send using the address number. For information on how
to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.
2
Select [+ Add] to perform Multiple Relay Broadcast.
Note
3
Press the <Start> button.
 Manual Send (Transmitting with picking up the receiver or on-hook)
1
Select the [More Options] tab to display the [More Options] screen.
2
Pick up the telephone receiver, or select [On-
hook (Manual Send/Receive)].
3
Select [Manual Send] from the drop-down
menu.
4
Use the keyboard displayed on the touch screen to enter numbers in the following format.
Relay station
telephone
number
Note
Password
• By default, no password is set. For setting a password, contact our Customer Support Center. If a
password is not set, you do not need to enter one.
• You can specify up to 20 locations for relay recipients.
Beep!
Facsimile tone
• You can specify up to 20 locations for relay recipients.
Relay Address
Address
station number
number
ID
Password
Relay
Address
station
number
ID
Broadcast
4
Beep!
219