Table of Contents
Advertisement
Chapter 9 Appendix
Chapter 9 Appendix
LCD Panel
This section explains the details of an event/error code that appears when an event occurs. If there is a
corresponding corrective action described for the code, try it first. If the code is still displayed, contact Buffalo
technical support for assistance.
Modes
LCD Message
LANx
Not Connected
LANx Full Duplex
10 Mbps
Link Speed
LANx Full Duplex
Note: The "x" is
100 Mbps
the number of the
LANx
LAN port where
1000 Mbps
the Ethernet cable
LANx
is connected.
2.5 Gbps
LANx
5 Gbps
LANx
10 Gbps
Used Space
Drive Space Used
C: 15% D: 0%
Windows Storage
Installed OS
Server 2016
Hostname and IP
WS5420DN6xxx
Address of LAN
192.168.11.150
Port 1
Date Time
Date and Time
YYYY/MM/DD
hh:mm
IP Addresses of
LANx
LAN Ports 2 and 3
192.168.11.150
Errors and Status
If an error occurs, one of the following messages will appear on the LCD panel and the error LED will glow red. You
can also check the current status using NAS Navigator2.
Note: The "x" in the LCD message is the number of the drive or assigned drive letter involved in the process.
Description
Not connected to a network.
Connected at 10 Mbps full duplex.
Connected at 100 Mbps full duplex.
Connected at 1000 Mbps.
Connected at 2.5 Gbps.
Connected at 5 Gbps.
Connected at 10 Gbps.
Displays the used space for drive C and D on
the TeraStation.
Displays the OS installed on the TeraStation.
Displays the hostname and the IP address of
LAN port 1.
Note: This example is using a WS5420DN6
unit. The "x" in the hostname is the last three
digits of the MAC address.
Displays the date and time set in the
TeraStation.
Displays the IP addresses of LAN ports 2 and
3.
124
Corrective Action
Connect an Ethernet
cable to the LAN
port.
-
-
-
-
-
-
-
-
-
-
-
Advertisement
Table of Contents
