Table of Contents
Advertisement
Chapter 9 Appendix
LCD Panel
The LCD panel can be cycled through different modes by pressing the display button on the front of the TeraStation.
Modes
Link Speed
Note: When an Ethernet cable is
connected to LAN Port 2, "LINK
SPEED 2" is displayed.
Disk Space Used
Hostname/IP Address
Calendar/Clock
Installed OS
IP Address 2
Errors and Status
LCD Message
SYSTEM Error E11
Fan Failure
SYSTEM Error E12
Cooling Failure
LCD Message
LINK SPEED
No LINK
LINK SPEED
10Mbps
LINK SPEED
100Mbps
LINK SPEED
1000Mbps
HDD
USED
WS5200DR2xxx
192.168.11.150
DATE TIME
2013/1/1 11:11
Windows Storage Server
2012 R2
NETWORK2
192.168.11.151
Description
An error occurred in the fan speed.
A rise in the system temperature
may have exceeded the allowable
safety value.
Not connected to network.
Connected at 10 Mbps.
Connected at 100 Mbps.
Connected at 1000 Mbps full duplex.
Bar graphs are shown to indicate the used
space for the C, D, E, and F internal drives of
the TeraStation. When a hard drive is full, it is
indicated by "^".
Displays the hostname and IP address.
Note: If the hostname contains multibyte
characters, they will be replaced with
question marks (?) on the LCD panel.
Displays the date and time set in the
TeraStation.
Displays the OS installed on the TeraStation.
Displays the IP address of LAN port 2 when
an Ethernet cable is connected to LAN port 2.
Check that no foreign objects or dust are
clogging the fan. If any foreign objects or
dust are found, use a pair of tweezers, air
duster, or other tool to remove them. If the
error is displayed again, contact Buffalo
technical support for assistance.
Do not place objects in the area around
the TeraStation. Also, move the TeraStation
to a cool location. Make sure that the
TeraStation's fan is working normally.
99
Description
Corrective Action
Advertisement
Table of Contents
