Installing Your Software; Unpacking Your 653X Device - National Instruments 653X User Manual

Device Supported
PCI-DIO-32HS
AT-DIO-32HS
PXI-6533
DAQCard-6533 for PCMCIA
PXI-6534
PCI-6534
PCI or PXI-7030/6533

Installing Your Software

Note It is important to install the NI-DAQ driver software before installing your device(s)
to ensure the device(s) are properly detected.

Unpacking Your 653X Device

Never touch the exposed pins of connectors to prevent electrostatic discharge
Caution
from damaging the device.
© National Instruments Corporation
To download a free copy of the most recent version of NI-DAQ, click
Download Software at
device using the following table:
Windows
Version 5.0 or later
Version 5.0 or later
Version 5.1 or later
Version 5.1 or later
Version 6.9 or later
Version 6.9 or later
Version 6.5.2 or later
Install application development software, such as LabVIEW or
Measurement Studio, according to instructions on the CD and the release
notes. If NI-DAQ was not installed with your ADE, then install NI-DAQ
according to the instructions on the CD and the DAQ Quick Start Guide
included with your device.
Your 653X device is shipped in an antistatic package to prevent
electrostatic damage to the device. To avoid such damage in handling the
device, take the following precautions:
• Ground yourself via a grounding strap or by holding a grounded object.
• Touch the antistatic package to a metal part of your computer chassis
before removing the device from the package.
Chapter 1
. Find NI-DAQ compatibility for your
ni.com
NI-DAQ Version
Version 6.1.0 or later
N/A
Version 6.1.3 or later
Version 6.1.0 or later
N/A
N/A
N/A
1-5
Getting Started with Your 653X
Mac
653X User Manual