Table of Contents
Advertisement
Using the Integrated Panel Mount Slots
You can also mount the NI WSN-3226 to a panel using the integrated panel mount slots as shown in
Figure 9.
1.
Attach three number 8 or M4 pan head screws in the mounting panel, leaving 0.1 in. space under
the head of each screw. Refer to Figure 2 for the correct hole pattern and dimensions.
2.
Slide the NI WSN-3226 device onto the panel.
Note
In this configuration, the NI WSN-3226 is held in place only by the weight of the device and
the friction of the screw attachment. Use the DIN rail clip or panel mount accessories in high
vibration environments.
Caution
Disconnect power before removing the device from the panel.
Setting Up the NI WSN-3226 Device
The following sections discuss setting up the NI WSN-3226 for use.
Installing the Software
You must be an Administrator to install NI software and devices on your computer. Before connecting
the hardware, install the following software in the following order:
1.
NI LabVIEW, available at
2.
NI-WSN and NI MAX, which are included on the software installation disc included with your
NI WSN gateway and are also available for download at
Note
After installation of NI-WSN, the NI Wireless Sensor Network Getting Started Guide is
available from Start»All Programs»National Instruments»NI-WSN.
© National Instruments Corporation
Figure 9. Integrated Panel Mount Slots
.
ni.com/support
11
.
ni.com/support
NI WSN-3226 User Guide and Specifications
Advertisement
Table of Contents
