National Instruments 653X User Manual page 104

Device
PCI-6534
PCI-DIO-32HS
AT-DIO-32HS
PXI-6534
PXI-6533
DAQCard-6533
for PCMCIA
Optional Equipment for Connecting Signals
© National Instruments Corporation
Table C-4. 50-Pin Accessories
Shielded Cable
SH68-68-D1
SH68-68-D1
PSHR68-68M
To use your 653X device with cables, signal conditioning modules, and
other accessories that require an AT-DIO-32F pinout, use the R6850-D1,
an optional 68-to-50-pin device adapter. Using a PSHR68-68M shielded
cable, you can also connect the adapter to a DAQCard 6533 device.
The female side of the R6850-D1 adapter connects directly to the
653X device or PSHR68-68M cable. The male side of the adapter provides
the pin assignments shown in Figure C-2. The 50-pin adapter has no +5 V,
CPULL, or DPULL pins.
National Instruments offers a variety of accessories to extend your
653X device capabilities, including:
• Cables and cable assemblies, shielded and ribbon
• Connector blocks, shielded and unshielded 50 and 68-pin screw
terminals
• RTSI bus cables for AT and PCI devices
• SCXI modules and accessories that can acquire up to 3072 channels,
and that can isolate, amplify, excite, and multiplex signals for relays
and analog output
• Low channel-count signal conditioning modules, devices, and
accessories, including conditioning for strain gauges and RTDs,
simultaneous sample and hold, relays, and optical isolation
For more information about these products, refer to your National
Instruments catalog, Website, or call the office nearest you.
Appendix C
Ribbon Cable
R6868
R6868
N/A
C-7
Connecting Signals with Accessories
Cable Adapter
R6850-D1
(Converts 68 pin to 50 pin)
R6850-D1
(Converts 68 pin to 50 pin)
R6850-D1
(Converts 68 pin to 50 pin)
653X User Manual