Verifying The Kit Contents; Installing Software On The Host Computer; Installing C Series Modules - National Instruments NI-9147 Getting Started

Note
3. Unpack any other items and documentation from the kit.
Store the device in the antistatic package when the device is not in use.

Verifying the Kit Contents

Verify that the following items are included in the NI-9147 kit.

Installing Software on the Host Computer

Before using the NI-9147, you must install the following application software and
device drivers on the host computer in this order:
1. LabVIEW 2014 SP1 or later
2. LabVIEW FPGA Module 2014 SP1 or later
3. NI-RIO Device Drivers 14.5 or later
For minimum software support information, visit
Code swsupport.
1
LabVIEW FPGA Module is not required when using Scan Interface mode. To
program the user-accessible FPGA on the NI-9147, LabVIEW FPGA Module is
required.

Installing C Series Modules

Complete the following steps to install a C Series module.
Do not install a device if it appears damaged in any way.
NI-9147 Getting Started
ni.com/info and enter the Info
7
© National Instruments